UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Every time I run Cura, when I go to load a mesh it always kills off Cura with the message Cura has stopped responding, windows will look for a solution and then it tells me it is closing the program. Always been the case. Currently trying as follows:
Cura 2.7
Windows 10 (up to date)
Graphics card (AMD R9 270) installed properly and working
Plenty of RAM ands storage
Anyone got any ideas
Last install was done after removing all other cura files completly, i.e. no left over files from previous installs
Cura Always falls over
in UltiMaker Cura
Posted
Every time I run Cura, when I go to load a mesh it always kills off Cura with the message Cura has stopped responding, windows will look for a solution and then it tells me it is closing the program. Always been the case. Currently trying as follows:
Cura 2.7
Windows 10 (up to date)
Graphics card (AMD R9 270) installed properly and working
Plenty of RAM ands storage
Anyone got any ideas
Last install was done after removing all other cura files completly, i.e. no left over files from previous installs
Thanks