VMaxx
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by VMaxx
-
-
I'm giving a mixing nozzle a try for the first time.
I have it setup with the two extruders the second has HIPS in it for support. I have it set so that extruder 1 is my regular filament and 2 for support.
It seems to be priming between doing walls and infill unexpectantly. I found a setting for infill extruder and it was set to "not overriden" so I changed it to match extruder 1, but it still does a prime after doing the wall and infill wasting filament. I'm wondering if I'm missing something if anyone has seen this.
TIA!
-
I'll have to research. I'm not sure if I can put more buttons on the monitor screen.
-
No it's a clone of the Octoprint one, it basically lets you print directly to repetier server without needing to load up Repetier Host. It will display your camera if you have it and show you the print progress. The cancel and pause don't seem to have handlers in the Octoprint plugin to send commands to cancel a job, so I couldn't clone them in my plugin. You can however, make it move, home etc via the monitor page.
-
I cloned the Octoprint Plugin and created one for Repetier server so Cura can print to it.
-
1
-
Priming between infill and walls
in UltiMaker Cura
Posted
Ok its apparently not between infill and walls. Its doing walls and infill then priming and doing a second pass of wall and infill, then primes to do support.