UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In an attempt to level my printer more accurately, I was going through the manual leveling process. However, I have a 1+ cm gap between the extruder and the nozzle. I cannot even come close to getting the initial 1 mm gap before using the calibration card. Is there a way to manually raise the build plate prior to honing the calibration via the three screws below the build plate?
Manual Leveling Error
in UltiMaker 3D printers
Posted
In an attempt to level my printer more accurately, I was going through the manual leveling process. However, I have a 1+ cm gap between the extruder and the nozzle. I cannot even come close to getting the initial 1 mm gap before using the calibration card. Is there a way to manually raise the build plate prior to honing the calibration via the three screws below the build plate?