Jimbo965
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Jimbo965
-
-
1 minute ago, itretail said:
Getting ready to recover to previous version, with the instructions posted by Gr5, anyone know if there is a later recovery image available as this one seems to be 2017.
The recovery image seems to have been updated as I followed Gr5 instrusctions and version 4.3.3.20180529 was on the printer after the power cycle
-
4 hours ago, piphil said:
How did you do this? I can't find the older firmware online?
I used this to recover:
-
3 hours ago, viola0083 said:
I'm desperate with this 5.2.8 firmware, please enlighten me how to restore to earlier version
I followed the instructions to recover from the link below. Need to create a recovery image on microSD and plug it in the processor board and let it boot up. Then power cycle and recalibrate the print head swap position. I haven't done it before and it was pretty straightforward.
-
8 hours ago, viola0083 said:
my problems on Ultimaker 3 after installing firmware 5.2.8 are:
- no Wifi (haven't try the camera) after doing factory reset
- cannot print if using S3D, I have also sent email to S3D for possible solution, they have worked a
temporary U3 profile for firmware 5.2.8, I have tried and tested a few times but still have some problems:
--- the machine will keep asking me to use the printhead that's not designated in my Gcode.
am still keep trying and also same time hope Ultimaker can make a really stable firmware soon!
attached S3D Profile for UM3, please try and share
S3d Profile for Ultimaker 3 (5.2.8 firmware)
best regards
I also got the new profile from S3D but there appear to be more issues with 5.2.8 than just Gcode. Have now recovered my UM3 to last version before 5.2.8 and all is working again.
Wasted few hours on this and won't make the mistake of just accepting a firmware upgrade in future :-)
- 1
-
Just loaded the 5.2 firmware and S3D files won't print. Cura prints are working but I also need to be able to print S3D files.
Hope there will be a fix or workaround for this soon?
Ultimaker Firmware 5.2 stable
in Firmware
Posted
What about the problems with printing S3D files? That's a common problem in this thread...