UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Is there is the way to improve the initial top layer thickness when using the adaptive layer height? This is the beginning before the 1st top layer is printed on the infill
On the next layer height of 101, the 1st top layer is printed but the initial thickness base on the layer preview shown the thickness to be 0.05mm which is to thin to support the rest of the top layer .
Is there any post-processing g-code to make the adaptive layer to ignore the initial top layer or a way to increase the initial top layer layer thickness when using adaptive layer thickness
Suggestion to improves the adaptive layer height
in UltiMaker Cura
Posted
Is there is the way to improve the initial top layer thickness when using the adaptive layer height? This is the beginning before the 1st top layer is printed on the infill
On the next layer height of 101, the 1st top layer is printed but the initial thickness base on the layer preview shown the thickness to be 0.05mm which is to thin to support the rest of the top layer .
Is there any post-processing g-code to make the adaptive layer to ignore the initial top layer or a way to increase the initial top layer layer thickness when using adaptive layer thickness