Jump to content

Tibi

Dormant
  • Posts

    3
  • Joined

  • Last visited

Posts posted by Tibi

  1. Hi there.

    I made one column without any problem.

    See my last print of this night (I was confident since my other prints were ok) ... and it stopped 4cm before the end.

    I had a cloud of plastic in the printer (see first picture).

    Strange as well is the melted zone in the close-up picture. Like if the nozzle was staying there.

    Maybe I should go for a wider brim : what do you think ?

     

    those problems happened after the upgrade to firmware 4.3.20180308 ... is there a way to go back to a previous version ?

     

    I'll go for a factory reset of the printer and re-re-re-test

    IMG_1019.JPG

    IMG_2628.JPG

  2. Hi there, many thanks for your feedbacks.

    Yesterday I spent time in cleaning parts, lube and leveling to start from scratch.

    Aaaaand this is the result of this night print ... even worse :-)

    I guess my cleaning was to good and adherence was worse than before ... 

    See the de-alignment on top of printing ... is it due to non sticking on glass bed ?

    IMG_1566.JPG

    IMG_1512.JPG

    IMG_3577.JPG

  3. Hi there, 

    My first post here :-)

    See picture attached ... 

    Printing PLA White at 0,3 mm layer and getting this 1 out of 3 times.

    Any clue about what I should do to avoid it ?

     

    0,3 mm is ti get a printing in 14 hours instead of 21 hours . Maybe I should go back to 0,2

    I read that maybe I need to recalibrate the plate : I'll try it.

    IMG_6600.JPG

×
×
  • Create New...