UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Today I installed Cura and tried to perform the Build plate leveling.
There I get a problem: the head goes to the front left position, I calibrate the position with a piece of paper. The display of the controller tells me that the z position is 3 mm here.
So far so good.
But then the head goes to the front right position and changes the z position to 6 mm. Therefore I can`t adjust the level at this position because the plate is too low :-(
I can`t reach the distance 0.1 mm with the spring.
Build plate leveling: z level changes
in Improve your 3D prints
Posted
Hi,
I just assembled my new Ultimaker Original +.
Today I installed Cura and tried to perform the Build plate leveling.
There I get a problem: the head goes to the front left position, I calibrate the position with a piece of paper. The display of the controller tells me that the z position is 3 mm here.
So far so good.
But then the head goes to the front right position and changes the z position to 6 mm. Therefore I can`t adjust the level at this position because the plate is too low :-(
I can`t reach the distance 0.1 mm with the spring.
I hope someone can help me
Kind regards,
Vinzenz