UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I own an Anet A8 and have trouble at the edges of my printings where the infill seems to be very weak. This happens only at the start of each layer but as the printing starts at the same edge each layer it leaves a smaller or bigger hole.
What can I do to improve the printing quality? I am currently using Marlin 1.8 and Cura 3.3.
Weak infill at start of layer
in Improve your 3D prints
Posted
Hello,
I own an Anet A8 and have trouble at the edges of my printings where the infill seems to be very weak. This happens only at the start of each layer but as the printing starts at the same edge each layer it leaves a smaller or bigger hole.
What can I do to improve the printing quality? I am currently using Marlin 1.8 and Cura 3.3.
I appreciate every tip and help I can get!