[How to force retracts for ALL travel moves?]

never mind, found the comb distance setting.

 

 

 

[How to force retracts for ALL travel moves?]

1 minute ago, KickahaOta said:

There's a link to the beta binaries on the Ultimaker Cura download page, https://ultimaker.com/en/products/ultimaker-cura-software .

 

 

Excellent, thanks so much!

[How to force retracts for ALL travel moves?]

Awww, hurry up and wait I guess ? Any source for pre-compiled beta binaries?

[How to force retracts for ALL travel moves?]

16 hours ago, smartavionics said:

There is also now a Max Comb Distance With No Retract setting that when set to a non-zero value, all combing moves longer than that distance will use retraction (but not z-hop). So this gives you the ability to comb short distances and retract for long distance travel.

 

This sounds perfect! If I understand correctly, it will retract "while" combing? And this is available in the current release of Cura? I'm away from my PC right now but I'm excited to check ASAP.

[How to force retracts for ALL travel moves?]

I couldn't figure out how to edit my initial post, but I figured out my problem was I had "combing" enabled. Combing moves do not include retracting. So I can get nice retracts with no  combing, or I can get combing with no retracts. Any way to get both?

[How to force retracts for ALL travel moves?]

Hello! I am getting good prints except for my non-retracted travels leaving blobs everywhere. When cura does retract the travel areas look good. How do I force Cura to retract for ALL travel moves?