rsiudak
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by rsiudak
-
-
22 minutes ago, Digibike said:
Hi,
I get the Information, that there is a new Firmware. So I had choose it and the Printer (UM3 E) will install it fine.
But now, he will never Print from USB? All Files, which will Print perfectly with the Firmware before, will get
the Information at start, that the Print will be finished in 0 h 0 min and 0 sec. The Printer will also don´t Print
the files.
What is wrong with it?
What can I do to correct it? I only Print from USB.
How can I roll back, if there is no Chance to corect it now? The Printer will only Show that the FW is the latest.
A factory-Reset don´t helped. The Problem is the same as before the factory-reset...
Hope, someone can help!
With regards, Digibike
Can you provide more details so that the problem can be understood better. To what version did you update, since this update is a special one, actually two updates are required.
The first update is the stable 4.3.96, after installation it should show a newer version in the stable menu 5.2.8.
Then did you slice your models again with the latest Cura version or what version are you using?
-
Hi Alexander,
If you are downloading the files on a Windows machine it could be that you have "hide extension for known filenames enabled" and therefore you are not viewing the proper extension and it could be you saved it with the wrong extension. If i download the latest version now, my filenames are correct. Since you are doing a long print we can at least test the following without updating the printer yet:
- If you are running Windows, make sure you have "extensions turned on", see: http://kb.winzip.com/kb/entry/26/ or https://www.thewindowsclub.com/show-file-extensions-in-windows.
- Then re-download the files from here: https://ultimaker.com/en/resources/23129-updating-the-firmware, check that the filenames are correct.
Kind regards,
Raymond.
-
Hi Alexander,
From you screenshots it looks like you are behind some sort of proxy that requires a login ("http://10.10.10.10/login.html?redirect= "). Are you on a network that requires a login before using the internet, e.g when using your phone?
And how did you proceed downloading the latest firmware for the UM3, i.e. what files did you put on the USB stick from where?
Kind regards,
Raymond.
Ultimaker Firmware 5.2 stable
in Firmware
Posted
The downloadable update is only temporarily not available. Online update is still possible.