heffneil
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by heffneil
-
-
Hey guys I am BRAND new to this so be gentle. I have an A8 Anet Printer. I am using Ultimaker Cura - latest version 3.4 I think. I have it running on a laptop plugged in to the wall and no power settings set to make it go to sleep. I seem to have an issue where the printer - on large prints - says "Click to Resume". I am not clear why this is happening or how to resolve it. I have the printer in the garage so its quite a schlep when it freezes up and I have to go out there. Also I have to deal with the blob of filament that melts where it is stuck. It is quite a problem. Any thoughts or ideas how to resolve this?
Thanks in advance!
Newbie issue
in UltiMaker Cura
Posted
I use Cura to monitor the printer. Shows how far along the print is and estimated time to complete. I am probably going to setup Octoprint but this is very odd that its stopping and looking to get a button pressed. Is there a limit on the amount of memory the printer can help if I am loading the data from the PC? I couldn't get it to work from the SD card - probably the SD card that came with it is bad....