UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
FYI, we have found that cause of material diameter problem on Creality Ender 3 in Cura 3.5, which by default will be 2.85mm instead of 1.75mm. For developers, the JIRA ticket for this problem is CURA-5806.
I tried to change the diameter to 1.75 manually. When I go to check the settings it still says the diameter is set to 1.75 but when I print it is still underextruding extremely much so apparently it doesn't change the setting where it matters.
Also, when I hit "print" the temperature always jumps to 210 degrees eventhough I have sliced it with a 190 degree setting.
All this is on Marlin firmware and Cure 3.5.
Cura version 3.4.1 works without a problem on the same model and settings.
New: Ultimaker Cura 3.5
in UltiMaker Cura
Posted
I tried to change the diameter to 1.75 manually. When I go to check the settings it still says the diameter is set to 1.75 but when I print it is still underextruding extremely much so apparently it doesn't change the setting where it matters.
Also, when I hit "print" the temperature always jumps to 210 degrees eventhough I have sliced it with a 190 degree setting.
All this is on Marlin firmware and Cure 3.5.
Cura version 3.4.1 works without a problem on the same model and settings.