[Extruder turns the wrong direction]

sorted it out -- I had an ultimaker 2 profile I automatically update the firmware through.  Doesn't appear the ultimaker informs what model it is when it does the firmware update automatically through Cura, but selects firmware based on the profile selected in Cura.

[Extruder turns the wrong direction]

I have a motor drive reversal issue as well. It was  working correctly, I did several prints, and then I decided to run firmware update through Cura 3.6  now the motor runs in reverse.  the firmware still shows the same number v3.3 -- this is a 2+ extended.

 

Where can I grab the firmware files to do a manual firmware update? I have already performed a factory reset, but the motor is still running backwards.

 

Thanks for any tips