[Cannot get Cura to make a decent print on my UM2+]

I have done Some printing with S3D and this is quite working better. Still figuring out the best settings. Outer layers look fine but needed to put the extruded factor almost to two before getting results with enough quality. Still figuring out how to get the outer walls connected with one another. Any tips?

[Cannot get Cura to make a decent print on my UM2+]

On 10/16/2018 at 4:08 PM, latreides said:

You assume that I have stayed on 2.5 (I was never on 2.4).  I keep my Cura up to date.  While Cura has gotten better, S3D still generates better GCode, has fewer issues and has many features that Cura lacks.  I still use Cura when doing dual extrusion on the UM3 because S3D's dual extrusion is terrible, but for all else, I find that S3D always has a better print.

 

Thanks I am going to try use s3D and will leave a comment on the results here. 

[Cannot get Cura to make a decent print on my UM2+]

I’m experiencing the same issues. Also in cues version 2.4. The strange thing , although not recommended, if I print over USB printing quality is fine. Gcode settings are set to Ultimaker2, also when is was printing over USB.  Firmaware is upgraded. 

 

Really lookinging to solve this having this problem for a long time.