Metalman54
-
Posts
11 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Metalman54
-
-
It was called eWASTE you can look it up. It took a lot of fiddling around to get a good print. Real good for learning but not for printing.
I attached a photo from the internet. Ours was built with wood not Plexiglas. spent about $90 to build.
-
Wow I,m 64 and raising a 13 year old. 3 years ago I built a 3d printer from 2 DVD drives X axis and Y axis. Z axis I used a 3.5 floppy drive.
This summer I bought a Anet A8 and watched my 13 year old grandson as he did the build. Now I know to use Solidworks to make this
model water tight. This is a awesome community. Thanks to all that chimed in and pushed me in the right direction.
Regards
Dan Welch
-
Support warped up and it crashed. Back to the drawing board.
-
Started the print and it’s just printing the support.
-
I just checked and now I can see support. My next question is how do you guys cut this support out? Exacto knife.
-
I just uploaded the stl of the model. In Cura first I scale it down to 30%. I get a little over 2Hr print time but I don't really see
were it added support for the print. Can anybody show me a screen shot of what it should look like?
-
Ok. I clicked support. I will try a print.
-
Anet A8, ABS, single extruder,hollow body about 8” long. Using Cura. Don’t know how to handle support to print this. But figure if I don’t have support it will not print right. I’m a beginner.
Ok sorry. I am using PLA. MY MISTAKE.
-
Anet A8, ABS, single extruder,hollow body about 8” long. Using Cura. Don’t know how to handle support to print this. But figure if I don’t have support it will not print right. I’m a beginner.
-
Getting ready to print General Lee body. Does anyone have some pointers?
Car body print
in Improve your 3D prints
Posted
Again thanks for all your help.