[One at a time. (Cura 3.6 on Ultimaker Original. )]

Thank you.

Will try beta then.

[One at a time. (Cura 3.6 on Ultimaker Original. )]

Hi Guys.

I usually print several small parts and I would prefer to have them come out one at a time. However when i activate this option the exclusion area around each part becomes huge. I can only fit 2 parts. I was able to do at least 9 in previous versions.

 

I have found several mentions to this issue, that are supposed to be fixed by setting the gantry height to anything over 120mm. I have gone up to 400mm and the issue remains. 

Any suggestions?

 

Print head dimension seem about right. 

 

Using Cura 3.6 on Ultimaker Original. 

 

Thank You