cp2004
-
Posts
7 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by cp2004
-
-
Does any one know of a way of changing the default load position from the middle of the build plate? Not a major gripe, however I have a mark on my build plate and only printing small models a lot of the time I keep forgetting to move them to other parts of the build plate to avoid the bubble.
-
I think the arrow is that way because when you move things around the bed it does it from the centre as opposed to your printer origin. The number in the box when you move are 0,0,0 by default in the centre when the model is loaded, then if you look at that whilst you move it is right. Agree that it is confusing as the x-axis and z-axis are different.
-
For your last suggestion, I think there is an option for that in the preferences, not enabled by default.
For your complaint, I'm not sure what you mean by the arrow in the negative direction. Mine points in the positive. Do you have any special config?
-
1
-
-
I have found the setting 'Fill gaps between walls, and turned it off. That was the problem here. Maybe something changed with how it behaves in 3.6. It's fixed for now.
-
I think you may have linked the wrong ticket, that one is about the fonts in cura 3.2...
Concentric Infill has similar effects, but not so bad. The infill percentage doesn't change this until it is 0%, in which case there is no fill.
Wall thickness option seems to have no effect. The issue is caused by having a part that is thinner than 2x total wall width, but thicker than 1 line of the wall so it does this strange infill pattern.
Attached is with concentric infill, then changing the wall width to be less, concentric infill. It seems to be a worse issue with the gyroid infill.
Minimum infill area is the only setting that I could see affecting it.
-
I have an issue with Cura filling objects with thin gaps between walls, where a part is with tiny zig-zag lines that slow down the print massively. From what I can remember this was an issue since 3.6 as it behaved differently before. This image describes the lines - https://i.redd.it/3ip9ep8ca7c21.png (from a reddit post) and I have had it with this christmas tree file attached below. I can confirm if it is also an issue in 4.0 as I have downloaded the beta.
I have seen various reports of this issue, it stresses printers frames and drastically slows print time.
Change default load position from (0,0)
in UltiMaker Cura
Posted
OK thanks for the confirmation.