VBill
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by VBill
-
-
My Cura profile : https://drive.google.com/file/d/1y8SF37k-5CYBk128MLVfaw_8yi1os8UR/view?usp=sharing
My gcode start :
G21 ;valeurs métriques
G90 ;positionnement absolu
M82 ;mettre l'extrudeuse en mode absolu
M107 ;commencez avec le ventilateur éteint
G28 X0 Y0 ;déplacer X / Y à des butées min
G28 Z0 ;déplacez Z en butées min
G0 X0 Y15 F9000 ;Lit en avant
G0 Z0.15 ;Déposer au lit
G92 E0 ;zéro la longueur extrudée
G1 X40 E10 F500 ;Extruder 10 mm de filament sur 4 cm
G92 E0 ;zéro la longueur extrudée
G1 E-1 F500 ;Rétracter un peu
G1 X80 F4000 ;Essuye rapidement la ligne de filament
G1 Z0.3 ;Levez et commencez à imprimer.
G1 F9000 ;Message imprimer
M117 Impression...
End :
M104 S0 ;chauffage de l'extrudeuse éteint
M140 S0 ;chauffe-lit chauffant éteint
G91 ;positionnement relatif
G1 E-1 F300 ;rétracter un peu le filament avant de soulever la buse, pour libérer une partie de la pression
G1 Z+0.5 E-5 X-20 Y-20 F9000 ;déplacez Z un peu et retirez le filament encore plus
G28 X0 Y0 ;déplacez X / Y jusqu'à la butée min, de sorte que la tête soit à l'écart
G90 ;positionnement absolu
G1 Y190 F9000 ;le lit se déplace vers l'avant
M84 ;steppers off
-
you can see conception here : https://www.tinkercad.com/things/jGtl7Fm6RlE-bouchon-reservoire
-
hello
I use an anet A8 with the original firmware and CURA since version 3.5.Since version 3.6 I have some problems:
On some parts the Z axis freezes.
For example my last print which is a total of 17mm high with supports, the printing starts and works very well up to 7.9mm then the Z axis remains locked at this value, but the printing of the layers does not stop. This damages the print head.
I tried to regenerate the gcode: idem
Other printing can be done without any problem
Of course I checked the functioning of the Z axis in manual mode and there is no problem.
Does anyone have any idea
Z axis freezes
in Improve your 3D prints
Posted
Hello
I have performed several checks including the gcode (thanks gr5)
I didn't find anything strange and the printing was blocked on the Z axis at the end of the support (6.9mm for my part)
Finally I started again from the basic PLA Fine setting on CURA and is modified some parameters (temp, wall etc) and now everything works.
This is all weird.
Greetings