Avar
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Avar
-
-
Just, assambled new Ultimaker Original+, but cannot set bed level to the right pisition. When doing auto home on ulticontroller or bed leveling via Cura, the bed goes to the nozzle, touches it, z limit switch clicks, and then bed is going down about 150mm and stays there.
Ultimaker Original+ after z-limit swich clicks, bed goes down about 150mm when doing auto home
in UltiMaker 3D printers
Posted
Problem is solved, one wire connection to z-limit switch was loose.