UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Found it.
my Vref on the stepper-drivers was to low.
as a result the motor did not got enough power to move the printbed and skipped steps
(printbed is the heaviest part on my printer)
i increased the power from 0.72 to 8.7 and the problem dissapeared
the temp from the drivers rose from 55deg to 59deg
Henk
Great you find the answer. Before find your post I arrived to the same conclusion, It wasn't about something mechanical. did you change the power in the firmware or did it moving an internal potentiometer? I saw a video of someone doing it.
(SOLVED) Layer shifting (again)
in Improve your 3D prints
Posted
Great you find the answer. Before find your post I arrived to the same conclusion, It wasn't about something mechanical. did you change the power in the firmware or did it moving an internal potentiometer? I saw a video of someone doing it.
Thank you!