UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am actually not very impressed with 4.2.1 and have had to go back to 4.1.
The Print just suddenly stops printing on my Ender 3 for no reason, it just suddenly decides to stop.
Works fine for Short prints but I have just had my 3rd stop in the middle of a 6 hour print and no way to get it to start printing again, this is beyond annoying as I have to start again and have wasted 3 Hours and PLA.
There is No Error message it just stops printing and the software just stays at whatever % it was at.
Ultimaker Cura 4.2 released
in UltiMaker Cura
Posted
I am actually not very impressed with 4.2.1 and have had to go back to 4.1.
The Print just suddenly stops printing on my Ender 3 for no reason, it just suddenly decides to stop.
Works fine for Short prints but I have just had my 3rd stop in the middle of a 6 hour print and no way to get it to start printing again, this is beyond annoying as I have to start again and have wasted 3 Hours and PLA.
There is No Error message it just stops printing and the software just stays at whatever % it was at.