UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I designed a .58 caliber minnie ball (bullet) to print on my Creality CR-10s. When I put the model down on its base, so the nose is pointing straight up, I hit Prepare and the cupped end (which is a gentle cupped area requiring no supports), comes out flat and solid. Turn the model on its side, and the cupped end appears and also prints out. I'll enclose two snapshots of the original model, which one shows it standing straight up with a solid end on the bed vs the other is on its side and you can clearly see the cup on the end.
Is there a something I missed on the settings? Thanks in advance.
Orientation Issue with Cura (in general)
in UltiMaker Cura
Posted
I designed a .58 caliber minnie ball (bullet) to print on my Creality CR-10s. When I put the model down on its base, so the nose is pointing straight up, I hit Prepare and the cupped end (which is a gentle cupped area requiring no supports), comes out flat and solid. Turn the model on its side, and the cupped end appears and also prints out. I'll enclose two snapshots of the original model, which one shows it standing straight up with a solid end on the bed vs the other is on its side and you can clearly see the cup on the end.
Is there a something I missed on the settings? Thanks in advance.