UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have looked but have not found an answer for my situation.
I am looking to make solid infill parts and have my first layer 98% perfect with almost no mounding and everything 0.2mm which is my also first layer setting in cura 4.3. now my second layer if i use multiple bottom layers will mound the infill to a thickness of 0.4mm layer measured from the bottom overall thickness is now 0.6mm. My layer thickness is 0.2mm so i have a 150% overfilling at the peaks. I was able to get around this by doing a single bottom layer and infill at 75% is close but it is still slightly mounding for the second layer through the 4th layer then at layer 5 it starts printing with open gap like 75% infill should and does for the rest of the infill.
The esteps, nozzle diameter, filament diameter are all accounted for and setup properly. Is there a setting to adjust the bottom layer infill to compensate for over filling during the following bottom layer? Or alternative ideas for testing?
bottom layers Layer adjustments gradient infill?
in UltiMaker Cura
Posted
I have looked but have not found an answer for my situation.
I am looking to make solid infill parts and have my first layer 98% perfect with almost no mounding and everything 0.2mm which is my also first layer setting in cura 4.3. now my second layer if i use multiple bottom layers will mound the infill to a thickness of 0.4mm layer measured from the bottom overall thickness is now 0.6mm. My layer thickness is 0.2mm so i have a 150% overfilling at the peaks. I was able to get around this by doing a single bottom layer and infill at 75% is close but it is still slightly mounding for the second layer through the 4th layer then at layer 5 it starts printing with open gap like 75% infill should and does for the rest of the infill.
The esteps, nozzle diameter, filament diameter are all accounted for and setup properly. Is there a setting to adjust the bottom layer infill to compensate for over filling during the following bottom layer? Or alternative ideas for testing?