UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Just found out about Adaptive Layers. Awesome feature, everyone should know about it.
I did find a bug (I think) where a model has angles that call for adaptive layers. However, the layers only adapt within the middle range. See attached image:
Setting the adaptive layers threshold to 160 fixes it:
STL is from the Thingiverse Slack Lack. I'm not complaining, this bug isn't fatal. I just thought the Cura devs might like to know of an edge case to check out. Or maybe it's more than an edge case.
Adaptive layers bug
in UltiMaker Cura
Posted
Just found out about Adaptive Layers. Awesome feature, everyone should know about it.
I did find a bug (I think) where a model has angles that call for adaptive layers. However, the layers only adapt within the middle range. See attached image:
Setting the adaptive layers threshold to 160 fixes it:
STL is from the Thingiverse Slack Lack. I'm not complaining, this bug isn't fatal. I just thought the Cura devs might like to know of an edge case to check out. Or maybe it's more than an edge case.
SlackLack_-_Spacer_BL-1.STL