UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have an ender e3 and am trying to set it up with cura. However, the first layer always prints to high and does not stick to the bed. I have ensured that the printer is calibrated and the built in prints work.
Here is my start code:
G28 ; home all axes
M117 Purge extruder
G92 E0 ; reset extruder
G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
G1 X0.1 Y20 Z0.3 F5000.0 ; move to start-line position
G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; draw 1st line
G1 X0.4 Y200.0 Z0.3 F5000.0 ; move to side a little
G1 X0.4 Y20 Z0.3 F1500.0 E30 ; draw 2nd line
G92 E0 ; reset extruder
M117 All systems go!
difficulty printing with ender e3
in UltiMaker Cura
Posted
I have an ender e3 and am trying to set it up with cura. However, the first layer always prints to high and does not stick to the bed. I have ensured that the printer is calibrated and the built in prints work.
Here is my start code: