UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Ok so here's the deal. I don't think it's the SD card or the Printer. I was using Cura with Anycubic I3 Mega, it worked beautifully for nearly 6 months, then I upgraded my Cura software and bam! Every print I tried vis SDCard or USB Connection, the printer freezes every sing time the print starts. So for months I tried reverting to an older version of Cura, Nothing, replacing SD Card and the reader, I even swapped the mainboard. None of it worked. Then last week I tried installing Meshlab and low and behold with a USB cable the anycubic began printing again. Only problem being is that I had to install the anycubic manually so the bed doesn't line up with the program so the prints run off the bed.
The point? It's a problem with Cura not the Printer. I don't know how to fix my bed alignment issue yet but I thought I'd share what I've learned so far. If anyone has the answer for me I'd appreciate it.
Printer no longer reading cura generated gcode
in Improve your 3D prints
Posted
Ok so here's the deal. I don't think it's the SD card or the Printer. I was using Cura with Anycubic I3 Mega, it worked beautifully for nearly 6 months, then I upgraded my Cura software and bam! Every print I tried vis SDCard or USB Connection, the printer freezes every sing time the print starts. So for months I tried reverting to an older version of Cura, Nothing, replacing SD Card and the reader, I even swapped the mainboard. None of it worked. Then last week I tried installing Meshlab and low and behold with a USB cable the anycubic began printing again. Only problem being is that I had to install the anycubic manually so the bed doesn't line up with the program so the prints run off the bed.
The point? It's a problem with Cura not the Printer. I don't know how to fix my bed alignment issue yet but I thought I'd share what I've learned so far. If anyone has the answer for me I'd appreciate it.
Thanks.