UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Last week, I started working with a UMS5, after some former experience with a UMO/UM2E. The first models, I did in TPLA, supported by PVA. After dissolving the support, I sometimes have a very unconsistent and warped layer.
The bottom of my model that faced the build plate (rounded corner in the left is warped as well) looks quite terrible:
Unfortunately, I don't have the gcode files saved. The settings in Cura are like this (translation below):
Translation: Generate support / Support extruder / Support interface extruder / Support roof extruder / Support floor extruder / Placement support: everywhere
Setup: UMS5 with glass build plate with glue, TPLA/PVA, air manager.
I've been looking into this problem, but I cannot find a solution. Anyone any ideas?
Warping on supported bottom
in Improve your 3D prints
Posted · Edited by T_D
Hi there,
Last week, I started working with a UMS5, after some former experience with a UMO/UM2E. The first models, I did in TPLA, supported by PVA. After dissolving the support, I sometimes have a very unconsistent and warped layer.
The bottom of my model that faced the build plate (rounded corner in the left is warped as well) looks quite terrible:
Unfortunately, I don't have the gcode files saved. The settings in Cura are like this (translation below):
Translation: Generate support / Support extruder / Support interface extruder / Support roof extruder / Support floor extruder / Placement support: everywhere
Setup: UMS5 with glass build plate with glue, TPLA/PVA, air manager.
I've been looking into this problem, but I cannot find a solution. Anyone any ideas?
T_D