UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
After years of useful info in this forum i end up making an account because i need help:
my Ultimaker 2 is making a scratch sound, after hours of investigation i found that it is the X-axis in the hot-end-carriage that is ''scratching'' the linear bearing when moving backward? is that possible? when i look at the slider-block it is moving up and down with the past of the axis it is sliding on. I noticed the axis on the front side is also moving but just the tiniest bit.
Video of the slider block and the scratching sound:
all belts are on tension and i tighten all pulley. Any idea?
sliderblock moving up and down? change my bearings? video!
in Improve your 3D prints
Posted · Edited by Coenter
Hello,
After years of useful info in this forum i end up making an account because i need help:
my Ultimaker 2 is making a scratch sound, after hours of investigation i found that it is the X-axis in the hot-end-carriage that is ''scratching'' the linear bearing when moving backward? is that possible? when i look at the slider-block it is moving up and down with the past of the axis it is sliding on. I noticed the axis on the front side is also moving but just the tiniest bit.
Video of the slider block and the scratching sound:
all belts are on tension and i tighten all pulley. Any idea?