Jump to content

Aerospike

Member
  • Posts

    2
  • Joined

  • Last visited

Posts posted by Aerospike

  1. I recently noticed that when I increase my brim line count or width it also increase my outside margins. I'm trying to print an N-95 mask that only is touching the center area and flares out near the edge as it goes up. So the brim is no where near the edge, only the upper Z axis. Because of this my max brim can only be 2mm. Way too small. 

     

    Is there a setting that is active I don't know about that locks increased brim/skirt/raft width with the outside margins? Or a way to override the margins completely?

    10mm.JPG

    1mm.JPG

    Front.JPG

    Side.JPG

×
×
  • Create New...