UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have 2 Ultimaker3 and each one has a different problem with support structure.
Problem 1:
The first Ultimaker3 has the Problem that there is always a little gap between the support structure an the model. I tried to print a ball and because auf this problem the ball was deformed where the support structure should have been supporting.
Problem2:
The second Ultimaker3 has the Problem that the support structure merges with the print. At some points that I can see through the plate I printed and it leaves holes where the support structure was.
Ultimaker3 support structure problems
in Improve your 3D prints
Posted
I have 2 Ultimaker3 and each one has a different problem with support structure.
Problem 1:
The first Ultimaker3 has the Problem that there is always a little gap between the support structure an the model. I tried to print a ball and because auf this problem the ball was deformed where the support structure should have been supporting.
Problem2:
The second Ultimaker3 has the Problem that the support structure merges with the print. At some points that I can see through the plate I printed and it leaves holes where the support structure was.
I hope somebody has a solution for my problems.
Kind regards Frolic.