UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hello all, first post here. Glad to have found the community! I am trying the tree support feature, that seems like it would be a great fit for the standing tall models, like the one on my picture. But I always have this one problem - the trunk of that support, as it were, is always broken in the middle. As you can see on the print screen - it goes up until a certain point, and then the diameter suddenly jumps, which makes the part of the support above it fail.
I have played with the the tree support settings, but to no avail - best I can do is to move the breakage point up of down on the trunk, but it never fully goes away. I'll try post my settings, but I also tried to slice with the defaults - same result.
Tree Support alway has its trunk interrupted
in UltiMaker Cura
Posted
Hello all, first post here. Glad to have found the community! I am trying the tree support feature, that seems like it would be a great fit for the standing tall models, like the one on my picture. But I always have this one problem - the trunk of that support, as it were, is always broken in the middle. As you can see on the print screen - it goes up until a certain point, and then the diameter suddenly jumps, which makes the part of the support above it fail.
I have played with the the tree support settings, but to no avail - best I can do is to move the breakage point up of down on the trunk, but it never fully goes away. I'll try post my settings, but I also tried to slice with the defaults - same result.
Is there anything I can do?
Cura v. 4.6.1, MacOS