shvanbc
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by shvanbc
-
-
Hi,
I am printing the XYZ calibration cube (https://www.thingiverse.com/thing:1278865) which is 20mm in size. When it is sliced in Cura 4.6.1 with initial layer height = 0.1mm and layer height = 0.1mm the result is 198 layers. Shouldn't it be 200 layers? I also notice that when I measure with calipers it is short by approximately .15mm, whereas the X and Y are pretty close to 20mm.
Thanks,
Steve
Question about number of layers in Cura
in UltiMaker Cura
Posted
Thank you for your reply. You are correct about the "Slicing Tolerance" setting, I had set it to exclusive based on a suggestion I found elsewhere as something to try for better dimensional accuracy.
Honestly, I didn't understand from reading the description of that feature that it would impact the number of layers. I still don't get it but I will set it back to its default setting.
Thanks again for the help.