[setting home position]

Hi again Greg,

I am a newby, and I put the second lot of gcode (-29.834 etc) into Cura but the printer ( Ender 3 ) still goes to the bottom left of the plate, runs two lines just inside the y axis, then tries to do the prinr commencing there as well!!! What am I doing wrong? I am sure the printer settings are not compatible but cannot seem to change them! The read out states "too far out"!!!

HELP

G

[setting home position]

Thank you, Greg, very clear and concise, a great help.

G

[setting home position]

Even though the model is positioned in the centre of the build plate in Cura review, when I start the printer it moves over the the side and runs off the plate!!!! How do you reset the printer home position? does it have a relationship with the Cura review ?

Thanks

G

[BROG]

How do you get the model to lay flat on the build plate? I have tried to manipulate the model using the various controls in the LH column but do not have great succes!

[Cura software download]

I downloaded the Cura software but cannot open it. I am not particularly computer savvy and  every time I click on it a window comes up and asks if I would like to remove the original copy before installing again! It seems I am clicking on the EXE each time but I cannot find how to access the program! Any advice appreciated, thank you.

George