[Cura 4.6.1 Flow Rate Problems]

23 hours ago, nallath said:

That is because the flow on the screen of your printer is based on a change on what is in the g-code. It will always show 100%, regardless of what you change in Cura.

 

If that is the case, then why after making the above change in the g-code does it now show the new flow rate number I set it to?

[Cura 4.6.1 Flow Rate Problems]

Want to iterate same issue here on 4.6.1, adjusting the flow has no impact. This can be verified by going into Tune on the Ender during a print as previously stated, you will see no matter what the flow is always 100.