UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'm using the latest version of Cura and I'm using an Ender 3 pro, it isn't connected or anything. Quite simply I install the software and it takes roughly about 30 seconds before the entire program freezes. I can minimize and expand it on windows, but that's about it. The only way I can close it is to go into Task Manager and shut it down from there. I'm at a complete loss. I've tried running it as admin and in windows 8 compatibility mode. I've re-installed it several times and have used an earlier version - to the same effect. I have a slight suspicion that it might have to do with the fact that when I last used Cura it was on a hard drive that is now "dead" and it's still connected to the MB, just been too lazy/forgetful to take it out. Could that be an issue?
Cura is freezes when I start it
in UltiMaker Cura
Posted
I'm using the latest version of Cura and I'm using an Ender 3 pro, it isn't connected or anything. Quite simply I install the software and it takes roughly about 30 seconds before the entire program freezes. I can minimize and expand it on windows, but that's about it. The only way I can close it is to go into Task Manager and shut it down from there. I'm at a complete loss. I've tried running it as admin and in windows 8 compatibility mode. I've re-installed it several times and have used an earlier version - to the same effect. I have a slight suspicion that it might have to do with the fact that when I last used Cura it was on a hard drive that is now "dead" and it's still connected to the MB, just been too lazy/forgetful to take it out. Could that be an issue?
Help or advice would be much appreciated.
Thanks!