UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
That was the method I tried before, but the print still runs with the left extruder -- see attached screenshots to illustrate. Note that with Cura the print is centered on the bed, but when the Cura-generated g-code is opened in ideaMaker, the print is offset noticably to the left.
When talking about enabling the nozzles, were you referring to the side-by-side tabs in "PREPARE" mode, or the over-under checkboxes in "PREVIEW" mode?
I am not sure if you figured this out yet but in the start of the G code under machine settings, there is a hard coded T0 right before "M117 Printing..." that needs to be removed. After removing this, it seems to be choosing the correct nozzle.
Cura software and Raise 3D Pro Plus
in UltiMaker Cura
Posted
I am not sure if you figured this out yet but in the start of the G code under machine settings, there is a hard coded T0 right before "M117 Printing..." that needs to be removed. After removing this, it seems to be choosing the correct nozzle.