[Need Help. Poor ABS 3D Print Quality After Core Change]

Need help on what settings do I need to change to make this print with crisp edges again.  I had to replace the print core due to the brass heads being worn out and before the replace heads I had no problems printing this design.  All sides had clean edges before but now the bottom edge is very rough and this is the same profile that I was using before.  Here is my set up: 

 

Ultimaker S5

Matterhacker ABS Black (I have tried several different brand new rolls)

Printing Profile: Engineering-Normal 0.15mm

Printing Temperature 235 (Used a temp tower to determine best temp)

Infill Density is 20%

Building Plate is 95C

Print Speed is 30mm/s

Everything else is the stock settings.

 

 

 

 

[Help Improve ABS printing]

The black prints do the exact same thing.  I was thinking about widening the outer legs to get more print surface.  Great idea on slowing down the print on the legs.

[Help Improve ABS printing]

I am printing an object using matterhacker's ABS Black and White filament.  Heat is set to 233 speed is set to 70mm/s and the bed is at 100-C, also my Ultimaker S5 is fully enclosed.  Everything prints great except the 45 degree legs (see attached picture).  The interesting thing is that I only have the problem with 2 out of the 4 legs.  Any suggestions would be apricated.