UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
All I can say is wow. I will have to go check the settings if they need to be more specific. But I downloaded the new Arachne Software yesterday. Since that time, I printed a Water Tower and a Raspberry Pi case. With this update, I have had no under extrusion, stringing, and no blobs, that I have had in the latest stable version of Cura 4.8.
This is the first time since upgrading to a direct drive (which has given me slight headaches since June/July) that I am a thoroughly happy Ender 3 Pro consumer again. I'm really tempted to run a lithophane print on this and compare it to the one I just printed for my wife, but first I have to finish printing the water tower for my wife.
Special introduction: Ultimaker Cura engine improvements with Arachne alpha
in UltiMaker Cura
Posted
All I can say is wow. I will have to go check the settings if they need to be more specific. But I downloaded the new Arachne Software yesterday. Since that time, I printed a Water Tower and a Raspberry Pi case. With this update, I have had no under extrusion, stringing, and no blobs, that I have had in the latest stable version of Cura 4.8.
This is the first time since upgrading to a direct drive (which has given me slight headaches since June/July) that I am a thoroughly happy Ender 3 Pro consumer again. I'm really tempted to run a lithophane print on this and compare it to the one I just printed for my wife, but first I have to finish printing the water tower for my wife.
Keep it up guys.