benny22
-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by benny22
-
-
ohhh sorry - busy week. havent seen your reply till now. printer is at my friend's place. will look into it at the weekend. thanks for your patience!
-
thanks for the info. where can i find the "move material" option?
Had a friend look at the printer, he fiddled with the temrature settings of the nozzle, increasing it from the default to around 240 for regular PLA and that did the trick. I'm curious as to why isnt the default temp. good enough? why should i change it?
-
hi - hope this is the right spot for my question. i have a fairly new S3 (less than 6 months). Both extruders do not print out. Tried hot and cold nozzle clean, they ome out good, but when i tried to print, material comes out only at times and in very thin strips, sometimes vanishes at all. i played with the feeder tension screw - no help there.
I even replaced nozzles,,,, nothing😢 i'm lost. Please help!!!
material not extruding after nozzle clean
in Improve your 3D prints
Posted
OK -SO TEMPERATURE WAS SET TO 220 AND SPEED TO 40. DEFAULT IS 60 (RIGHT?)
WHAT ARE YOUR RECOMMENDATIONS?
thANKS !