UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have the same problem with the S5 “ultimaker s5 difference between height of both print cores exceeds realistic value” , when I do the manual bed calibration the right nozzle sometimes does not touch the bed, it returns 3-4 mm above the bed there is no problem with the left nozzle, after 3 times the right nozzle will go lower and then there is no problem. Also calibrated the switch that will lower the head.
Nozzle Offset Probe Failed
in UltiMaker 3D printers
Posted
Hello,
I have the same problem with the S5 “ultimaker s5 difference between height of both print cores exceeds realistic value” , when I do the manual bed calibration the right nozzle sometimes does not touch the bed, it returns 3-4 mm above the bed there is no problem with the left nozzle, after 3 times the right nozzle will go lower and then there is no problem. Also calibrated the switch that will lower the head.
Best regards,
Günther