UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So I’ve had an issue in a few prints, Cura is putting a “shell” around some figurines.
at first glance it looks like the print is low resolution but I’d you grab the surface with angle cutters it pulls away for the most part and underneath is the figurine. Most places it’s easy to remove in others it’s so stuck in place you cannot get it out.
im guessing it is support generation so for figurines any suggestions for making easy to remove reliable supports?
Odd support issue
in UltiMaker Cura
Posted
So I’ve had an issue in a few prints, Cura is putting a “shell” around some figurines.
at first glance it looks like the print is low resolution but I’d you grab the surface with angle cutters it pulls away for the most part and underneath is the figurine. Most places it’s easy to remove in others it’s so stuck in place you cannot get it out.
im guessing it is support generation so for figurines any suggestions for making easy to remove reliable supports?
also on some prints it leaves off bits of support