UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am having the same problem with my Geetech 3 in one printer, 3 extruders into 1 printhead.
At PLA change, is sits on the corners of a test block and waits to heat up, this is dribbling pla in a blob on top the corner. It sits and waits and waits until it is heated to up to start the next block.
I think the G0 X{prime_tower_position_x} Y{prime_tower_position_y} is the correct solution, allowing the print head to sit in the middle of the prime tower and it can dribble there!
I just do not know where and how to make this change in the G code.
Dual-extrusion - Heating takes place right on model
in UltiMaker Cura
Posted
I am having the same problem with my Geetech 3 in one printer, 3 extruders into 1 printhead.
At PLA change, is sits on the corners of a test block and waits to heat up, this is dribbling pla in a blob on top the corner. It sits and waits and waits until it is heated to up to start the next block.
I think the G0 X{prime_tower_position_x} Y{prime_tower_position_y} is the correct solution, allowing the print head to sit in the middle of the prime tower and it can dribble there!
I just do not know where and how to make this change in the G code.