UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have a bricked UM3 and I tried these steps with no luck.
I formatted the micro SD as FAT32 (probably unnecessary), plugged it into my laptop, and used ApplePiBaker to "Restore" the SD card with the recovery.img file. No response from the UM3. Any suggestions on next steps?
The red light on the Olimax and the green light on the white board are both on. Fan runs for about three seconds when you turn the printer on then stops.
Recovering a Bricked UM3/S3/S5
in Firmware
Posted
Hi @gr5!
I have a bricked UM3 and I tried these steps with no luck.
I formatted the micro SD as FAT32 (probably unnecessary), plugged it into my laptop, and used ApplePiBaker to "Restore" the SD card with the recovery.img file. No response from the UM3. Any suggestions on next steps?
The red light on the Olimax and the green light on the white board are both on. Fan runs for about three seconds when you turn the printer on then stops.