UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Ive been using S5 for around 1 year, and until recent few weeks it was superb experience. Recently, feeder started to ground the filament similar as explained on the link problem. When that happen on the display appears the message which says that there is not enough material in the feeder and printing process stops. That usually happen 1.5h or 2h after starting the printing process. Nozzle is 0.4 mm diameter, materials I use are PLA or PETG and almost all settings are kept at their default values. Cura slicer is 4.9.1 and S5 firmware is up to the date. Hot and cold pull also are done several times, Bowden tube is clean, rubber cover from the nozzle is replaced, nozzle surface is clean, feeder is also cleaned, tension mark is at the middle. Also, Ive tried to print the same project on to the 2nd extruder, or to switch places of the printing cores, but same problem happened. If anyone has some advice I would be very grateful!
Material seems to be empty, but its not
in UltiMaker.com
Posted
Hello everyone,
Ive been using S5 for around 1 year, and until recent few weeks it was superb experience. Recently, feeder started to ground the filament similar as explained on the link problem. When that happen on the display appears the message which says that there is not enough material in the feeder and printing process stops. That usually happen 1.5h or 2h after starting the printing process. Nozzle is 0.4 mm diameter, materials I use are PLA or PETG and almost all settings are kept at their default values. Cura slicer is 4.9.1 and S5 firmware is up to the date. Hot and cold pull also are done several times, Bowden tube is clean, rubber cover from the nozzle is replaced, nozzle surface is clean, feeder is also cleaned, tension mark is at the middle. Also, Ive tried to print the same project on to the 2nd extruder, or to switch places of the printing cores, but same problem happened. If anyone has some advice I would be very grateful!