[fimware update !]

i use ultimaker original 

[fimware update !]

Hi everyone !

i just have a question :

is it possible to update the firmware with ultimaker controller via SD ?

if yes how ?

[i need help with my UMO]

Hi again
i have tried to contact 3DPrint.tn but no answer... 

do ultimaker still sell "ultimaker pcb 1.5.7 control board" cause i can buy it from france if existed !!
if no can i use another control board ? if so which one ?
i'm really in the average of losing hope to fix this .. !!!

[i need help with my UMO]

thank you for responding 🙂

yes i mean the full electroniques are missing i have Ultimaker original with no heated bed

what i have mounted now are : 4 stepper motors, 6 endstops,2 cables for lcd, 1 tempeture sensor for the extruder, and 2 fans (one for the extruder and the other for the missing board v1.5.7), and 2 lcd cables
here's a picture that could be helpful

[i need help with my UMO]

Hi everyone i'm totally new to 3d printing i just got my hands on a UMO without a board control (v1.5.7) i have tried finding it for a while but no luck.

i searched i lil bit about board control that can replace it so i found most of the ppl use the ramps 1.4

my question is will it work on UMO ? if so does it take the same power supply !?

also if anyone have another ideas i'm all ears.