UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thanks for the help. I will check these settings. I did try normal supports and the same thing happened - only one support generated. Strange this is that this morning I revised the print temperature and build plate temperature down by 10C and switched off the fan (it was at 10%) and re sliced, tree supports were then generated for all three holes. I’m using ASA, it’s recommended not to use a fan so supports are required. Will switch back to normal supports.