[Layer thicknesses are not equal.]

yes it shows many layers in the simulation. but it does not print the layers the simulation shows.

I made a new 3D model to check if the model was wrong but the same result again.

 

UMS5_Støpeform.3mf

[Layer thicknesses are not equal.]

3 hours ago, Chris1982 said:

I have tried to print this three times and I have checked the preview in cura ,  counted the number of layers it should print.  but it does not print it  even if it does it  in the simulation.

The other surfaces are correct. only last top surface that is wrong.

 

 

UMS5_Støpeform PXminicatch REV 2 front.ufp

[Layer thicknesses are not equal.]

I have tried to print this three times and I have checked the preview in cura ,  counted the number of layers it should print.  but it does not print it  even if it does it  in the simulation.

The other surfaces are correct. only last top surface that is wrong.