UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We have this issue with support material adhering to the prints as seen in the photos below. I'm not too familiar with common 3d printer issues but from what I understand, it looks like the PLA is under-extruding and the support material is filling in the gap. Are there some recommended settings to prevent this from happening?
What causes this?
in Improve your 3D prints
Posted
We have this issue with support material adhering to the prints as seen in the photos below. I'm not too familiar with common 3d printer issues but from what I understand, it looks like the PLA is under-extruding and the support material is filling in the gap. Are there some recommended settings to prevent this from happening?
Thanks