UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hi! I had the same problem. I thought that the solution is to change the 'Support Top Distance'. But affter some testings, I figured out that the solution in my case was 'Support X/Y Distance'. I set the 'Minimum Support X/Y Distance' to 0.0mm. Then i set the 'Support X/Y Distance' to 0.1. You can try with different values, but in my case, the Support could't touch the surface of the model by using a a value higher than 3mm.
(Tree) Support not getting close enough to model on specific detail?
in UltiMaker Cura
Posted
Hi! I had the same problem. I thought that the solution is to change the 'Support Top Distance'. But affter some testings, I figured out that the solution in my case was 'Support X/Y Distance'. I set the 'Minimum Support X/Y Distance' to 0.0mm. Then i set the 'Support X/Y Distance' to 0.1. You can try with different values, but in my case, the Support could't touch the surface of the model by using a a value higher than 3mm.