UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Is there any way to tell cura to go concentric (as the black lines show). It would be good for the first layer where it prints bridges or prints above a support. The Walls are always printed very nice because they are one line. But the parts where it prints a "bottom layer" with "lines" it doesnt wor well...
Concerning this part i wat to expand the bridge lines into the part. It doesn't hold like this.
Improve Bridges and Overhangs
in Improve your 3D prints
Posted
Hello,
Is there any way to tell cura to go concentric (as the black lines show). It would be good for the first layer where it prints bridges or prints above a support. The Walls are always printed very nice because they are one line. But the parts where it prints a "bottom layer" with "lines" it doesnt wor well...
Concerning this part i wat to expand the bridge lines into the part. It doesn't hold like this.
Thanks!